Dowel-cutting Cradle | Popular Woodworking


We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.

I find cutting dowels on the band saw to be a hassle. For one thing, the blade can grab the round stock and twist it out of your hand if you’re not using a support cradle guided by the miter gauge. And if you’re cutting several dowels to the same length, you have to set up a stop of some sort. Even then, the cut dowels tend to fly to the floor afterward.

Instead, I use this simple fixture for most of my dowel-cutting chores. It’s nothing more than a 10″-long pine 2×4 with a V-groove sawn into one edge. I attached a plastic 6″ ruler to the right side’s front face with double-sided tape and extended the inch marks across the flats on the top face. I cut a saw kerf at the zero end of the ruler, a bit deeper than the depth of the groove and screwed two 1⁄4″-thick plywood vertical guides on the left side of the saw kerf.

To use the jig, clamp it in a face vise, then feed the dowel stock from left to right. Line up the end of the dowel with the desired length on the ruler, and cut it off with a small backsaw. If I have a large number of dowels to cut, I put a bucket on the floor to catch them as they fall off the end of the jig. — Craig Bentzley


Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.





Source link

We will be happy to hear your thoughts

Leave a reply

RigalShop
Logo
Enable registration in settings - general
Compare items
  • Total (0)
Compare
0
Shopping cart