Crosshairs on Router Table Zero in On Bit Center Points – Woodworking | Blog | Videos | Plans


Crosshairs on Router Table Zero in On Bit Center Points

I often need a reference to the exact center of a router bit on my router table. I usually had to resort to measuring, which was not always accurate. To solve the problem for good, I decided to mark “crosshairs” onto the table to indicate the precise center of any bit.

Rockler v-groove router bit

I tightened a V-groove bit into my router collet, so that the point of the bit would indicate the center of the router shaft. Then, using a 90° triangle aligned with the table edges, I marked lines directly over the point of the bit with a fine-tip permanent marker. Now the center of any bit is a certainty!

– Bill Wells
Olympia, Washington





Source link

We will be happy to hear your thoughts

Leave a reply

RigalShop
Logo
Enable registration in settings - general
Compare items
  • Total (0)
Compare
0
Shopping cart